Solid State Relay - REVO-S 2PH 690V-500A

£1.00
Part Number:
REVO-S 2PH 690V-500A

Compact & low cost, the New REVO-S 2 Phase solid state relay / thyristor power controller is designed to replace contactors and is suitable for all resistive switching applications.

REVO-S 2PH is a self-contained unit mounted on CD Automation designed heat-sinks, optimised for maximum heat dissipation. Integral quick-blow fuse & holder can be supplied on unit sizes 30A to 40A units as an option, with internal fixed fuses on 60A upwards as standard.

The REVO-S thyristor unit also has the option of 4-20mA or 0-10Vdc linear input with Burst Firing set for 4, 8 or 16 cycles. Heater break alarm available as an option.

  • Thyristor suitable for resistive, medium or long wave infrared and heater battery loads
  • Current range - 30A, 35A, 40A, 60A, 90A, 120A, 150A, 180A, 210A, 280A, 400A, 450A, 500A, 600A, 700A
  • Supply voltage up to 480V or 600V AC as option
  • Fully isolated from the power
  • Zero crossing firing mode (ZC) or Burst Firing (4, 8 or 16 cycles selectable)
  • Logic input signal 4 to 30V DC typical (SSR) plus 4-20mA or 0-10V DC Linear input as an option
  • Constant current drain, independent of supply voltage with SSR input
  • Heater Break (HB) alarm to diagnose partial or total load failure with automatic setting, relay alarm output and front LED indication. Available as an option
  • Side by side mounting
  • Special design Heatsink with high dissipation value
  • IP20 protection
  • Complies with CE and cUL specification
  • Can be used in conjunction with REVO-PC to provide multi-zone control
More Information
Product Name Solid State Relay - REVO-S 2PH 690V-500A
Software N/A
Firing Range Zero Cross (SC), Burst Firing (BF)
Input Signal

DC logic (SSR), 4-20mA, 0-10Vdc

Communication None
Feedback Type Open loop
Option Heater Break Alarm
Ideal For Normal Resistance, Medium & Long Wave Infrared load types
Approvals cUL and CE + EMC approved
Altitude Over 1000m of altitude reduce the nominal current of 2% for each 100m.
Auxiliary Voltage Supply

12:24Vac/dc (30A to 210A only with DC Linear input or HBA), otherwise available as follows:

90:130Vac 8VA Max
170:265Vac 8VA Max (Standard)
230:345Vac 8VA Max
300:530Vac 8VA Max (Standard)
510:690Vac 8VA Max

Controlled Phases 2
Heater Break Alarm To diagnose partial or total load failure with automatic setup, relay alarm output and LED indication, available as an option
Humidity From 5 to 95% but without condensation or surface ice
Mounting Screw mounting
Load Type 3 Phase (3 wire - no neutral)
Panel Sealing IP20
Storage Temperature -25 °C to 50 °C Max
Voltage Power Supply 480V, 600V and 690Vac
Voltage Frequency Automatically from 47 to 70 Hz
Product Splash N/A
Copyright © 2018 CD Automation Ltd . All rights reserved.